Xerox WorkCentre 5222 Service Manual page 1268

Chain-Link Name
013-024 Front Booklet Staple Motor Forward ON/
OFF
013-025 Front Booklet Staple Motor Reverse ON/
OFF
013-026 Rear Booklet Staple Motor Forward ON/
OFF
013-027 Rear Booklet Staple Motor Reverse ON/
OFF
013-028 Booklet Staple Move Motor IN
013-029 Booklet Staple Move Motor OUT
042-001 MAIN MOTOR ON
042-002 FUSER FAN MOTOR (HIGH SPEED)
042-003 ROS FAN MOTOR ON
047-001 OFFSET MOTOR1 FORWARD ROTA-
TION
047-002 FUSER FAN MOTOR(HIGH SPEED)
047-003 OFFSET MOTOR2 FORWARD ROTA-
TION
047-004 OFFSET MOTOR2 REVERSE ROTA-
TION
047-005 OFFSET MOTOR1 REVERSE ROTA-
TION
047-006 MAIN MOTOR
047-022 EXIT DRIVE MOTOR FORWARD(Eject
Paper out)
047-023 EXIT DRIVE MOTOR REVERSE(send
paper into Dup)
047-024 EXIT GATE SOLENOID
047-025 FACE UP GATE SOLENOID
047-026 EXIT 2 FAN
061-001 ROS MOTOR ON
071-001 TRAY1 LIFTER UP(FEED MOTOR
Reverse)
Launch Version
WorkCentre 5225, 5230
Table 2 Output Component Control Codes IOT
Connector
Level Meaning
H = ON Same as Name
H = ON Same as Name
H = ON Same as Name
H = ON Same as Name
Pulse ON Booklet Stapler moves to the IN side X
Pulse ON Booklet Stapler moves to the OUT
side
L Same as Name
- Fuser Fan changes from Low to High
Rotation.
L ROS Fan Motor Start & Stop
- Same as Name
- Fuser Fan changes from Low to High
Rotation.
- Same as Name
- Same as Name
- Same as Name
L Same as Name
- Same as Name
- Same as Name
H Switch Gate to Exit2/FUT
L Switch FUT Gate to Face Up Tray
- Exit 2 FAN rotating
L ROS Motor Start & Stop
- Turn Lift Up Motor on for two sec-
onds when Tray 1 Level Sensor is
''L''(lifted down). Lifter Motor will not
rotate when Tray 1 Level Sensor is
''H''(lifted up).
February, 2008
6-129
Timer Off Cycle Operation Remarks
X X
X X
X X
X X
X 350 pulses
X X 350 pulses
X X Not Available
X X Not Available
X X Not Available
X X EXIT
X X Not Available
X X EXIT
X X EXIT
X X EXIT
X X Not Available
X X Not Available
X X Not Available
X X Not Available
X X EXIT
X X Not Available
X X Not Available
O X Not Available
General Procedures
Component Control