Removing The Support Bearing (J0Fa42234); Removing The Stapler Assembly (J0Fa42219); Rep 22.5.5 Lower Chute Assembly - Xerox WorkCentre 5222 Service Manual

8. Remove the Support Bearing from the Main Paddle Shaft Assembly.
(1)Remove E-Clip.
(2)Remove Support Bearing.
Figure 6 Removing the Support Bearing (j0fa42234)
Replacement
1. Reverse the removal procedure for replacement.
Launch Version
WorkCentre 5225, 5230
(Figure 6)

REP 22.5.5 Lower Chute Assembly

Parts List on
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Remove the A-Finisher from the machine.
2. Remove the Compile Assembly.
3. Turn over the A-Finisher (Transport).
4. Remove the Stapler Assembly.
(1)Release Clamps (2) and remove the wires.
(2)Disconnect Connectors (2).
(3)Remove Screws (2).
(4)Remove Stapler Assembly.
5. Turn over the A-Finisher.
February, 2008
4-191
PL 22.5
WARNING
(REP 22.1)
(REP 22.9.1)
(Figure 1)
Figure 1 Removing the Stapler Assembly (j0fa42219)
Repairs and Adjustments
REP 22.5.4, REP 22.5.5