Disconnecting The Connector; Removing The Gear Assembly (J0St40201); Rep 2.1.1 Feeder 1 Assembly - Xerox WorkCentre 5222 Service Manual

REP 2.1.1 Feeder 1 Assembly

Parts List on PL 2.1
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical power
applied to the machine.
1. Remove the MPT Assembly. (REP
2. Disconnect the HCF (Paper Tray 6) and move it aside.
3. Remove the L/H Upper Cover Unit.
4. Preparing to remove the Gear Assembly.
a. Remove the wire harness from the Gear Assembly holder
b. Remove the screws (2)
b
Remove screws (2)
Figure 1 Removing the Gear Assembly (j0st40201)
5. Removing the Gear Assembly (Figure
Launch Version
WorkCentre 5225, 5230
WARNING
7.1.1)
(REP 2.6.2)
(Figure 1)
a
Remove harness
2)
a. Remove the Gear Assembly
b. Disconnect the connector
a
Remove the Gear Assembly
Figure 2 Disconnecting the connector
6. Remove Tray 1.
7. Preparing to remove the Feeder 1 Assembly.
1. Disconnect the connector.
2. Release the Wire Harness from the clamps (2).
3. Remove the screws (2).
February, 2008
4-7
b
Disconnect the connector
(Figure 3)
Repairs and Adjustments
REP 2.1.1