072-101 Tray 2 Misfeed Jam Rap - Xerox WorkCentre 5222 Service Manual

072-101 Tray 2 MisFeed JAM RAP

BSD-ON:7.8/8.2
After the Tray 2 Feed/Lift Motor turned On, the Tray 2 Feed Out Sensor did not turn On within
the specified time.
Initial Actions
• Power OFF/ON
Procedure
Check the Transport Roll for wear and paper powder. The Transport Roll is ok.
Y N
Replace the Transport Roll.
Check for foreign substances, distortion and paper powder in the paper transport path. No
distortion, foreign substances, or paper powder are found in the paper transport path.
Y N
Clear away the foreign substances and paper powder. Correct the distortion.
Execute Component Control[071-100 Tray 2 Feed Out Sensor]. Actuate the Tray 2 Feed Out
Sensor (PL 2.5) with paper. The display changes.
Y N
Check the connections of P/J105, P/J608
are connected correctly.
Y N
Connect P/J105, P/J608 and P/J410.
Check the wire between J105 and J410 for an open circuit or a short circuit (BSD 8.2).
The wire between J105 and J410 is conducting without an open circuit or a short
circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the MCU PWB P410-6 (+) and GND (-) (BSD 8.2
The voltage is approx. +5VDC.
Y N
Replace the MCU PWB (PL 9.1).
Measure the voltage between the MCU PWB P410-8 (+) and GND (-) (BSD 8.2
Actuate the Tray 2 Feed Out Sensor
Y N
Replace the Tray 2 Feed Out Sensor
Replace the MCU PWB (PL 9.1).
Execute Component Control[071-008 Tray 2 Feed/Lift Motor ON]. The Tray 2 Feed/Lift Motor
(PL 2.3) can be heard.
Y N
Check the connections of P/J202, P/J602
are connected correctly.
A
Launch Version
WorkCentre 5225, 5230
and P/J410. P/J105, P/J608 and
(PL 2.5) with paper. The voltage changes.
(PL 2.5).
and P/J409. P/J202, P/J602 and
A
Y N
Connect P/J202,
Remove the Tray 2 Feed/Lift Motor
Replace the Tray 2 Feed/Lift Motor with the Tray 1 Feed/Lift Motor.
Execute Component Control[071-008 Tray 2 Feed/Lift Motor ON]. The Tray 1 Feed/Lift
Motor (PL 2.3) can be heard.
Y N
Return the Tray 1 Feed/Lift Motor to its original position.
Check the wire between J202 and J409 for an open circuit or a short circuit (BSD 7.8
Flag 1). The wire between J202 and J409 is conducting without an open circuit
or a short circuit.
Y N
Repair the open circuit or short circuit.
Replace the MCU PWB
Return the Tray 1 Feed/Lift Motor to its original position.
Replace the Tray 2 Feed/Lift Motor
P/J410
Replace the MCU PWB (PL 9.1).
Flag 2).
Flag 1).
P/J409
February, 2008
2-525
P/J602 and P/J409.
(PL 2.3) and the Tray 1 Feed/Lift Motor
(PL 9.1).
(PL 2.3).
(PL 2.3).
Status Indicator Raps
072-101