Installing The Bushing, Spring And Gear Onto The Rear Of The Shaft; Aligning The Gears And Stack Height Sensor Flag (J0St41723) - Xerox WorkCentre 5222 Service Manual

1 2 3
Bearing Spring Gear
Figure 13 Installing the Bushing, Spring and Gear onto the rear of the Shaft (j0st41724)
7. Rotate the Set Clamp Shaft until the Stack Height Sensor Flag is in the position shown in
Figure 14. Then position the 2 gears into the configuration as shown in
Repairs and Adjustments
REP 16.2.13
4
Install the Stack Height Sensor Flag onto
the rear end of the Shaft as shown
Figure 14.
2
Position the 2 Gears into the
position shown here
Figure 14 Aligning the Gears and Stack Height Sensor Flag (j0st41723)
8. Attach the Spring to the gear and slide the Gear into position.
9. Ensure that the 2 Gears and Stack Height Sensor Flag is in the position shown
and install the E-ring.
February, 2008
4-150
1
Rotate shaft until Stack
Height Flag is in position
Figure 15
Launch Version
WorkCentre 5225, 5230