Removing The Ros Fan And Set It Aside; Removing The Ros Unit (J0St40304) - Xerox WorkCentre 5222 Service Manual

Figure 7 Removing the ROS Fan and set it aside
9. Remove the ROS Unit. (Figure 8)
1.Remove the screws (x5).
2.Remove the ROS Unit.
Repairs and Adjustments
REP 3.1.1
1
Remove the screws (2)
Replacement
When connecting the connector of the Toner Crum PWB, be careful not to press too hard such
that the PWB is shifted.
NOTE: When the ROS Unit is being installed, be careful to properly seat the ROS Unit in to the
two locating holes in the machine frame.
1. To install, carry out the removal steps in reverse order.
February, 2008
4-22
Figure 8 Removing the ROS Unit (j0st40304)
CAUTION
Launch Version
WorkCentre 5225, 5230