5.
Remove the Full Rate Carriage.
(Figure
1.
Remove the screws (x2).
2.
Remove the Full Rate Carriage.
Figure 3 Removing the Full Rate Carriage (j0st41126)
6.
Remove the Lamp Wire Harness from the Full Rate Carriage.
1.
Turn over the Full Rate Carriage.
2.
Remove the screw.
3.
Remove the guide.
4.
Disconnect the connector.
5.
Remove the Lamp Wire Harness.
Launch Version
WorkCentre 5225, 5230
3)
(Figure
4)
Figure 4 Removing the Lamp Wire Harness (j0st41127)
Replacement
1.
To install, carry out the removal steps in reverse order.
NOTE: Adjust the positions of the Full Rate/Half Rate Carriages after installation.
11.6.1)
February, 2008
4-79
(ADJ
Repairs and Adjustments
REP 11.6.2