Xerox WorkCentre 5222 Service Manual page 992

4. Remove the KL-Clips from the Eject Shaft.
(1)Remove KL-Clips (2).
Figure 2 Removing the KL-Clips (j0fa42273)
5. Remove the Eject Shaft from the Front/Rear Tamper Motor Assembly.
(1)Move Bearings (2) in the direction of the arrows.
(2)Remove Eject Shaft in the direction of the arrow.
(3)Remove the Belts from the Pulleys.
Figure 3 Removing the Eject Shaft (j0fa42274)
Launch Version
WorkCentre 5225, 5230
(Figure 2)
(Figure 3)
6. Remove the Front/Rear Tamper Motor Assembly.
(1)Remove Tapping Screws (2).
(2)Remove Screw.
(3)Remove Front/Rear Tamper Motor Assembly.
Figure 4 Removing the Front/Rear Tamper Motor Assembly (j0fa42285)
Replacement
1. Reverse the removal procedure for replacement.
2. Install and align the Eject Belts with the marks on the Pulleys.
Figure 5 Installing the Eject Belts (j0fa42278)
February, 2008
4-215
(Figure 4)
(Figure 5)
Repairs and Adjustments
REP 22.10.1