Component Control
Purpose
The purpose of the Component Control is to display the logic state of input signals and to ener-
gize output components.
NOTE: Refer to
Table
1,
Table 2
for a list of all Input Components listed by Chain/Link ID num-
ber. Refer to
Table
2,
Table 4
for a list of all Output Components listed by Chain/Link ID num-
ber.
Procedure
1.
Access Diagnostic Routines.
a.
Enter UI Diagnostics
(UI Diagnostic
2.
Select Maintenance/Diagnostics.
3.
Select IO Checks.
4.
Select Component Control.
5.
Input Chain-Link number, then press Start button.
•
In case of INPUT Component:
Indicates current status in Status column.
Count up (+1) when switching. (High to Low, Low to High)
•
In case of OUTPUT Component:
Activates component
6.
Press Stop button after confirming.
Launch Version
WorkCentre 5225, 5230
Mode).
February, 2008
6-123
General Procedures
Component Control