077-113 Iot Exit Sensor Off Jam Straight Rap; 077-114 Exit 2 Sensor Static Jam Rap - Xerox WorkCentre 5222 Service Manual

077-113 IOT Exit Sensor OFF JAM Straight RAP

BSD-ON:10.3/10.4
After the Exit 2 Sensor turned On, the Exit 2 Sensor did not turn Off within the specified time.
Initial Actions
• Power OFF/ON
Procedure
Check the installation of the Exit 2 Module. The Exit 2 Module is installed correctly.
Y N
Install the Exit 2 Module correctly.
Check the Transport Roll for wear and paper powder. The Transport Roll is ok.
Y N
Replace the Transport Roll.
Check for foreign substances, distortion and paper powder in the paper transport path. No
distortion, foreign substances, or paper powder are found in the paper transport path.
Y N
Clear away the foreign substances and paper powder. Correct the distortion.
Execute Component Control [071-110 Exit 2 Sensor]. Actuate the Exit 2 Sensor
paper. The display changes to H.
Y N
Check the wire between P/J112 and
10.3 Flag 1/Flag 2). The wire between J112 and J434 is conducting without an open
circuit or a short circuit.
Y N
Repair the open circuit or short circuit.
Replace the Exit 2 Sensor (PL 6.4). If the problem persists, replace the Exit PWB
9.1).
Execute Component Control [047-023 Exit 2 Motor ON]. The Exit 2 Motor
heard.
Y N
Check the wire between P/J208 and
10.4 Flag 1). The wire between J208 and J433 is conducting without an open circuit
or a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the resistance of the Exit 2 Motor
J208-2/3/4/5 (BSD 10.4 Flag 2). The resistance is approx. 10Ohm.
Y N
Replace the Exit 2 Motor (PL
Replace the Exit 2 Motor (PL 6.4). If the problem persists, replace the Exit PWB
Replace the Exit PWB (PL 9.1).
Status Indicator Raps
077-113 , 077-114
P/J434 for an open circuit or a short circuit (BSD
(PL
P/J433 for an open circuit or a short circuit (BSD
(PL 6.4) between J208-1 and each point of
6.4).

077-114 Exit 2 Sensor Static JAM RAP

BSD-ON:8.7/9.3
Paper remains on the Exit 2 Sensor.
Initial Actions
• Power OFF/ON
Procedure
Execute Component Control
paper. The display changes to H.
Y N
Check the wire between
10.3 Flag 1/Flag
circuit or a short circuit.
Y N
Repair the open circuit or short circuit.
Replace the Exit 2 Sensor
9.1).
Replace the Exit PWB
(PL 6.4) with
(PL
6.4) can be
(PL 9.1).
February, 2008
2-548
[071-110 Exit 2 Sensor]. Actuate the Exit 2 Sensor
P/J112 and P/J434 for an open circuit or a short circuit (BSD
2). The wire between J112 and J434 is conducting without an open
(PL 6.4). If the problem persists, replace the Exit PWB
(PL 9.1).
(PL 6.4) with
(PL
Launch Version
WorkCentre 5225, 5230