124-706 Folding Cancelled Rap; 124-708 Output Tray Changed To Sub Tray Rap - Xerox WorkCentre 5222 Service Manual

124-706 Folding Cancelled RAP

Fold request is canceled to continue printing.
Procedure
Ask customer to check the job setup.
Status Indicator Raps
124-706, 124-708

124-708 Output Tray Changed to Sub Tray RAP

Output destination is changed to Sub Tray to continue printing.
Procedure
Paper is output to Center Tray instead of designated tray.
(1) Paper of different size from paper size designated with duplex designation is fed.
(2) Puncher of Finisher C has failure.
[(1)Output to Sub Tray at size mismatch occurrence in duplex designation]
-When size mismatch occurs, paper is output to the designated tray while Simplex is designated
and to Sub Tray while Duplex is designated.
-On the control panel, message saying that output destination is changed to Sub Tray is displayed
when Sheet Delivered is received from IOT, with the message, "Copying in progress" displayed
after Start button is pressed, until IOT is stopped.
-No display on the driver.
[(2) Output to Sub Tray at the occurrence of Finisher failure]
-Decurler failure and Puncher failure shall be handled not as SubSystemFail but as LocalFail.
-When Decurler failure occurs, paper is output to designated Finisher.
-When Puncher failure occurs, paper is output to Sub Tray.
-When Booklet is designated, however, paper is output to Booklet.
-On the control panel, message saying that output destination is changed to Sub Tray is displayed
when SheetDelivered is received from IOT, with the message, "Copying in progress" displayed
after
Start button is pressed, until IOT is stopped.
February, 2008
2-692
Launch Version
WorkCentre 5225, 5230