Xerox WorkCentre 5222 Service Manual page 399

024-989 Booklet Low Staple R
BSD-ON:12.27
Booklet Stapler Low Staple Rear signal was detected just before Stapling operation.
Booklet Stapler Low Staple Rear signal was detected at Power ON, at initialization, or when the
interlock was closed.
Procedure
Supply the staples. The problem is resolved.
Y N
Enter Component Control [013-108 Rear Low Staple Switch]. Select Start. 'LOW'
ples available) is displayed
Y N
Check the connections of J8894,
connected correctly.
Y N
Connect the connectors.
Check the wire between J8895 and J8995 for an open circuit or a short circuit (BSD
12.27). The wire between J8895 and J8995 is conducting without an open cir-
cuit or a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the Finisher PWB P8995-14 (+) and GND (-) (BSD
12.27). The voltage is approx. +5VDC.
Y N
Replace the Finisher PWB
Measure the voltage between the Finisher PWB P8895-1 (+) and GND (-) (BSD
12.27). The voltage is approx. +5VDC.
Y N
Replace the Rear Low Staple Switch
Replace the Finisher PWB (PL
Select Stop. Replace the Finisher PWB
Booklet PWB (PL 23.21).
If the problem continues, replace the Finisher PWB
the Booklet PWB (PL 23.21).
Status Indicator Raps
024-989
P/J8995 and P/J8892. The connectors
(PL 23.16).
(PL 23.20).
23.16).
(PL 23.16). If the problem continues, replace the
(PL 23.16). If the problem persists, replace
(sta-
are
February, 2008
2-376
Launch Version
WorkCentre 5225, 5230