Removing The Lever And Wire Harness; Removing The Dadf Feeder Assembly - Xerox WorkCentre 5222 Service Manual

Figure 2 Removing the Lever and Wire Harness
7. Remove the DADF Feeder Assembly.
1. Remove the screw (1).
2. Remove the Tapping Screws (6).
3. Release the wire harness from clamp.
4. Remove the DADF Feeder Assembly.
5. Remove the plunger.
6. When installing: Align the boss with the boss hole.
Launch Version
WorkCentre 5225, 5230
(Figure 3)
Figure 3 Removing the DADF Feeder Assembly
Replacement
1. To install, carry out the removal steps in reverse order.
2. When replacing, enter Diagnostic mode. Clear the [HFSI] counter.
February, 2008
4-107
Repairs and Adjustments
REP 15.2.2