Locating The Docking Latch Release (J0St41730.Jpg); Rep 16.2.1 Sb-Finisher Undocking - Xerox WorkCentre 5222 Service Manual

REP 16.2.1 SB-Finisher Undocking

Parts List on PL 23.1
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Switch off the power and disconnect the Printer power cord.
2. Disconnect the Finisher Power Cord, the H-Transport Connector and the Finisher Con-
nector from the IOT.
The Finisher is unstable when not docked with the Printer. Use care when handling an
undocked Finisher so that it does not fall over.
3. Release the Docking Latch on the Finisher and move the Finisher away from the Printer.
a. The docking latch is difficult to see when the Finisher is docked to the IOT. The figure
is shown with the finisher undocked to show the location of the latch and how to
actuate it.
b. Locate the docking latch from the rear of the Finisher and Printer.
Launch Version
WorkCentre 5225, 5230
WARNING
CAUTION
(Figure 1)
The docking
latch release
from the rear of
the Finisher and
Printer
Figure 1 Locating the docking latch release (j0st41730.jpg)
c. With a large common screwdriver release the docking latch by moving the latch
toward the front of the Finisher and move the Finisher away from the Printer.
2)
February, 2008
4-133
(Figure
Repairs and Adjustments
REP 16.2.1