Removing The Exit2+Oct2 (J0St40601); Rep 6.1.1 Exit2 + Oct2 - Xerox WorkCentre 5222 Service Manual

REP 6.1.1 Exit2 + OCT2

Parts List on PL 6.1
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
To prevent data loss when the power is turned off, please note the following.
[FAX Models]
Check that the "Stored Documents" lamp is not on, and press the Job Status] button to ensure
that there are no jobs in progress.
[Printer Models]
Check that "Ready to Print/Send" is displayed on the Control Panel display.
1. Open the L/H Upper Cover.
2. Remove the Exit2 + OCT2. (Figure
1. Lift up the front and rear levers and remove the Exit2 + OCT2.
Launch Version
WorkCentre 5225, 5230
WARNING
CAUTION
1)
Figure 1 Removing the Exit2+OCT2 (j0st40601)
Replacement
1. To install, carry out the removal steps in reverse order.
February, 2008
4-31
Repairs and Adjustments
REP 6.1.1