Removing The Spring (J0St41114); Winding The Carriage Cable Around The Pulley. 1/3 (J0St41115) - Xerox WorkCentre 5222 Service Manual

Figure 4 Removing the spring (j0st41114)
Replacement
1. Wind the Carriage Cable around the pulley.
1.Insert the Carriage Cable ball into the ditch of the pulley.
2.Wind the spring end of the cable around the pulley for 1.5 rounds.
3.Fix the cable at the spring end on the frame with tape.
4.Wind the cable at the ball end around the pulley for 2 rounds.
5.Fix the cable on the pulley with tape to prevent it from moving.
Launch Version
WorkCentre 5225, 5230
(Figure 5, Figure 6, Figure 7)
Figure 5 Winding the Carriage Cable around the pulley. 1/3 (j0st41115)
February, 2008
4-71
Repairs and Adjustments
REP 11.5.1