047-212 Oct 2 Rap - Xerox WorkCentre 5222 Service Manual

047-212 OCT 2 RAP

BSD-ON:10.7
the OCT Home Sensor 2 did not actuate in time after the OCT2 Motor energized.
Procedure
Manually operate the offset mechanism. The offset mechanism moves smoothly.
Y N
Replace the parts that are interfering with operation
Execute Component Control [047-206 OCT Home Sensor 2]. Actuate the OCT Home Sensor 2
with paper. The display changes.
Y N
Check the connections of P/J111, P606, J606, P/J434. Connections are connected
correctly.
Y N
Connect connectors
Check the wire between P/J111 and
10.7 Flag 1/Flag 2). The wires are conducting without an open circuit or a short cir-
cuit.
Y N
Repair the open circuit or short circuit.
Replace the OCT Home Sensor 2 (PL
Alternately execute Component Control [047-003 Offset Motor 2 (CW)] and
trol [047-004 Offset Motor 2 (CCW)]. The Offset Motor 2 energizes.
Y N
Check the connections of P/J207, P606, J606, and P/J433. Connections
nected correctly.
Y N
Connect connectors
Check the wire between J433 and P207 for an open circuit or a short circuit (BSD 10.7
Flag 3). The wires are conducting without an open circuit or a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the resistance of the Offset Motor 2 between J207-1 (COM) and each point of J207-
2/3/4/5 (BSD 10.7 Flag 3). The resistance is approx. 100Ohm.
Y N
Replace the Offset Motor 2 (PL
Measure the voltage between the Exit PWB P421-1 (+) and GND (-) (BSD 10.7
The voltage is approx. +24VDC.
Y N
Go to BSD 1.1 and troubleshoot the +24VDC circuit.
Replace the Offset Motor 2 (PL 6.4) If the problem persists, replace the MCU PWB
9.1).
A
Status Indicator Raps
047-212
(PL 6.1).
P/J434 for an open circuit or a short circuit (BSD
6.4).
Component Con-
6.4).
A
Replace the MCUPWB (PL
are con-
Flag 3).
(PL
February, 2008
2-504
9.1).
Launch Version
WorkCentre 5225, 5230