062-371 Lamp Illumination Rap - Xerox WorkCentre 5222 Service Manual

A B
Measure the resistance of the Carriage Motor
1/2 and J721-3/4/5/6 is approx. 1Ohm.
Y N
Replace the Carriage Motor (PL
Measure the voltage between the IIT/IPS PWB
6.3 Flag 1). The voltage is approx. +24VDC.
Y N
Replace the IIT/IPS PWB (PL 11.3).
Replace the Carriage Motor (PL 11.5)
If the problem persists, replace the IIT/IPS PWB
Replace the IIT/IPS PWB (PL 11.3).
Launch Version
WorkCentre 5225, 5230
(PL 11.5). The resistance between J721-
11.5).
(PL 11.3) P721-1/2 (+) and GND (-)(BSD
(PL 11.3).

062-371 Lamp Illumination RAP

BSD-ON: 6.3/6.2
The amount of light from Exposure Lamp is inadequate which gets incident on CCD at the start of
scan or at the initialization of IIT after power on.
Procedure
Check the lamp, lens, mirror and the white correcting plate for abnormalities such as contamination
and deterioration. Abnormality such as contamination or deterioration of the lamp, lens,
mirror or the white correcting plate is found.
Y N
Replace the lamp, lens, mirror or the white correcting plate.
Execute Component Control [062-002 IIT Exposure Lamp]. The Exposure Lamp lights up.
Y N
Check the connections of P/J703,
are connected correctly.
Y N
Connect P/J703, P/J702
Check the wire between J702 and J7231 for an open circuit or a short circuit. The
between J702 and J7231 is conducting without an open circuit or a short circuit.
Y N
Replace the Lamp Wire Harness
Measure the voltage between the IIT/IPS PWB
between P7231-2 (+) and GND (-) (BSD 6.3
Y N
Replace the IIT/IPS PWB
Replace the Exposure Lamp
If the problem persists, replace the Lamp Ballast PWB
If the problem persists, replace the IIT/IPS PWB
Check the connections of P/J700
rectly.
Y N
Connect P/J700 and P/J7101.
Replace the Lens Kit Assembly
If the problem persists, replace the IIT/IPS PWB
February, 2008
2-515
P/J702 and P/J7231. P/J703, P/J702
and P/J7231.
(PL 11.6).
(PL 13.3) P7231-1 (+) and GND (-), and
Flag 4). The voltage is approx. +24VDC.
(PL 11.3).
(PL 11.6)
(PL 11.6)
(PL 13.3).
and P/J7101. P/J700 and P/J7101 are connected cor-
(PL 11.4)
(PL 11.3).
Status Indicator Raps
062-360, 062-371
and P/J7231
wire