077-103 Fuser Exit Sensor Off Jam Rap - Xerox WorkCentre 5222 Service Manual

077-103 Fuser Exit Sensor Off JAM RAP

BSD-ON:10.2
After the Fuser Exit Sensor turned On, the Fuser Exit Sensor did not turn Off within the speci-
fied time.
Initial Actions
• Power OFF/ON
Procedure
Check the installation of the Fuser. The Fuser is installed correctly.
Y N
Install the Fuser correctly.
Check for foreign substances, distortion and paper powder in the paper transport path. No
distortion, foreign substances, or paper powder are found in the paper transport path.
Y N
Clear away the foreign substances and paper powder. Correct the distortion.
Open Left Upper Cover Assembly and verify that Exit 1 Gate
Gate is free to move.
Y N
Repair as required.
Check the clearance between the Diverter Gate and the Fixed Guide on the left hand door.
6.4- PL 6.5). Operation is satisfactory.
Y N
Repair as required (PL 6.4 - PL 6.5).
Execute Component Control [010-100 Fuser Exit Sensor]. Manually activate the actuator of the
Fuser Exit Sensor (PL 5.1). The display changes.
Y N
Check the connections of P/J125 and P/J410.
rectly.
Y N
Connect P/J125 and P/J410.
Check the wire between J125 and J410 for an open circuit or a short circuit (BSD 10.2
Flag 5/ Flag 6). The wire between J125 and J410 is conducting without an open cir-
cuit or a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the MCU PWB P410-1 (+) and GND (-) (BSD 10.2
The voltage is approx. +5VDC.
Y N
Replace the MCU PWB (PL 9.1).
Measure the voltage between the MCU PWB P410-3 (+) and GND (-) (BSD 10.2
Actuate the Fuser Exit Sensor with paper. The voltage changes.
A
Status Indicator Raps
077-103
(PL 6.2) is free to move. Exit 1
PL
P/J125 and P/J410 are connected cor-
Flag 6).
Flag 5).
February, 2008
2-544
A
Y N
Replace the Fuser Exit Sensor
Replace the MCU PWB (PL 9.1).
Execute Component Control [071-036 Main Motor ON]. The Main Motor in the Main Drive
Assembly starts rotating and the Fuser starts up.
Y N
Go to the OF 3 (MAIN DRIVE ASSY RAP).
Replace the MCU PWB (PL 9.1).
(PL 5.1).
Launch Version
WorkCentre 5225, 5230