Moving The Bearing (J0Fa42259); Removing The Stacker Shaft Assembly (J0Fa42260); Rep 22.8.3 Stacker Motor - Xerox WorkCentre 5222 Service Manual

12. Move the Bearing. (Figure 8)
(1)Remove E-Clip.
(2)Move Bearing in the direction of the arrow.
Figure 8 Moving the Bearing (j0fa42259)
13. Remove the Stacker Shaft Assembly.
(1)Remove Stacker Shaft Assembly in the direction of the arrows (lift up then out).
Figure 9 Removing the Stacker Shaft Assembly (j0fa42260)
Replacement
1. Reverse the removal procedure for replacement.
Repairs and Adjustments
REP 22.8.2, REP 22.8.3
(Figure 9)

REP 22.8.3 Stacker Motor

Parts List on PL 22.8
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Remove the A-Finisher from the machine.
2. Remove the Rear Cover.
3. Turn over the A-Finisher.
4. Remove the Tray Cover.
5. Disconnect the Connector.
(1)Release Clamps (3) and remove the wires.
(2)Release wires from Hook.
(3)Disconnect Connector.
Figure 1 Disconnecting the Connector (j0fa42261)
February, 2008
4-202
WARNING
(REP 22.1)
(PL 22.1)
(PL 22.2)
(Figure 1)
WorkCentre 5225, 5230
Launch Version