Removing The Exposure Lamp (J0St41124); Rep 11.6.1 Exposure Lamp - Xerox WorkCentre 5222 Service Manual

REP 11.6.1 Exposure Lamp

Parts List on PL 11.6
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Open the Platen Cover or DADF.
2. Remove the Platen Glass. (REP 11.1.1)
3. Move the Full Rate Carriage to the frame notch.
4. Remove the Exposure Lamp. (Figure
1. Disconnect the connector.
2. Remove the screw.
3. Remove the Exposure Lamp.
Figure 1 Removing the Exposure Lamp (j0st41124)
Launch Version
WorkCentre 5225, 5230
WARNING
1)
Replacement
1. To install, carry out the removal steps in reverse order.
February, 2008
4-77
Repairs and Adjustments
REP 11.6.1