091-912 Xerographics Drum Module Installation Rap; 091-913 Drum Cartridge End Of Life Rap - Xerox WorkCentre 5222 Service Manual

091-912 Xerographics Drum Module Installation RAP

BSD-ON:9.1/4.1
The Xerographics Drum is not installed.
Procedure
Check the installation of the Drum Cartridge
correct.
Y N
Correct the installation (PL 4.1).
Verify the condition of the circuit between the Drum Cartridge Position Sensor and MCU PWB. T h e
circuit is free of damage.
Y N
Repair the circuit as required.
Replace the MCU PWB (PL 9.1).
Launch Version
WorkCentre 5225, 5230
(PL 4.1). The Drum Cartridge installation is

091-913 Drum Cartridge End of Life RAP

BSD-ON:9.1
It is time to replace the Drum Cartridge.
Initial Actions
• Power Off/On
• Reload the Xero Drum Cartridge.
Procedure
Check the Drum Cartridge for failure or foreign substances. There are no foreign substances
and nothing has failed.
Y N
Repair the failure and remove the foreign substances.
Check the installation of the XERO CRUM PWB. The XERO CRUM PWB is installed correctly.
Y N
Install the XERO CRUM PWB correctly
Check the connection of the MCU PWB P/J419.
Y N
Connect P/J407.
Check the connection of the XERO CRUM PWB P/J126. P/J126 is connected correctly.
Y N
Connect P/J142.
Check the wire between J419 and P1126 for an open circuit or a short circuit (BSD 9.1). The wire is
conducting without an open circuit or a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the MCU PWB J419-1 (+) and GND (-) (BSD 9.1). The voltage is
approx. +5VDC.
Y N
Replace the MCU PWB
Replace the Drum Cartridge (PL
(PL 4.1) If the problem persists, replace the MCU PWB
February, 2008
2-569
(PL 4.2).
P/J419 is connected correctly.
(PL 9.1).
4.1) If the problem persists, replace the XERO CRUM PWB
(PL 9.1).
091-912, 091-913
Status Indicator Raps