Removing The Tamper Motor (J0St41728); Rep 16.2.23 Eject Motor; Rep 16.2.24 Front/Rear Tamper Motor - Xerox WorkCentre 5222 Service Manual

REP 16.2.23 Eject Motor

Parts List on PL 23.11
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Undock the Finisher. (REP 16.2.1)
2. Remove the Booklet Maker. (REP 16.3.2)
3. Remove the Rear Upper Cover. (REP
4. Remove the Eject Motor Assembly.
5. Remove the Eject Motor.
a. Remove the screws (2)
b. Remove the Eject motor
Replacement
1. To install, carry out the removal steps in reverse order.
Repairs and Adjustments
REP 16.2.23, REP 16.2.24
WARNING
16.2.3)
(REP 16.2.19)

REP 16.2.24 Front/Rear Tamper Motor

Parts List on PL 23.12
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Remove the Compiler Tray.
2. Turn the Compiler Tray over on a work surface.
3. Remove the Tamper Motor.
a. Release the wires from the wire guide.
b. Remove the screw (1) and remove the wire guide.
c. Disconnect the Tamper Motor connector.
NOTE: The Rear Tamper Motor connector has already been disconnected.
d. Remove the screws (2).
e. Remove the Tamper Motor.
2
Remove the screw (1)
Figure 1 Removing the Tamper Motor (j0st41728)
Replacement
Replace in reverse order of removal.
February, 2008
4-158
WARNING
(REP 16.2.13)
(Figure 1)
1
Remove wires from guide
WorkCentre 5225, 5230
4
Remove
the
screws
(2)
3
Discon-
nect the
connec-
tor
Launch Version