Nvm Read/Write - Xerox WorkCentre 5222 Service Manual

NVM Read/Write

Purpose
Reads, sets or changes the NVM data.
Procedure
1. Access Diagnostic Routines.
a. Enter UI Diagnostics (UI Diagnostic
b. Access Diagnostic Routines (UI Diagnostic
2. Select NVM Read/Write.
Reading NVM
1. Input Chain-Link number(6 digits) on NVM Read/Write screen.
2. Select Confirm/Change.
3. Current Value appears in Current Value column.
Writing NVM
1. Input New number in New Value column.
2. Select Save.
3. New number appears on Current Value column.
Table 1 Component VS Chain number
Component Item IOT/IIT/Controller
ESS IF IOT
Recycle IOT
Billing IOT
Drive IOT
NOHAD IOT
PH IOT
EXIT IOT
Tray IOT
Fuser IOT
ROS IOT
Process Control IOT
Xero IOT
CRU IOT
Finisher IOT
DADF IIT
IISS (DADF) IIT
IISS IIT
IISS (Config) IIT
Common Controller
Meter Counter Controller
Stored Data Controller
I/O Port Protocol Controller
Scan Service Controller
Launch Version
WorkCentre 5225, 5230
Mode).
Mode).
Chain Number Allocation
740
740
740
741
741
740, 742, 760
740, 742, 764
742
744
749
740, 751, 752, 753
740, 751
751
763, 764
711
710
715
719
700
720
731, 732, 733, 734
770
770, 840
Table 1 Component VS Chain number
Component Item
IOT
IIT
UI
Copy Service
Print Service
Fax Service
iFax Service
Diagnostics
February, 2008
6-7
IOT/IIT/Controller Chain Number Allocation
Controller 780
Controller 785
Controller 790
Controller 790, 810
Controller 800, 806
Controller 820, 823, 825
Controller 830
Controller 870, 900
NVM Read/Write
General Procedures