Adj 11.6.1 Full/Half Rate Carriage Position Adjustment - Xerox WorkCentre 5222 Service Manual

If the measured value in the copy is longer than the measured value in the Test Chart: Set
a smaller value.
Table 2 NVM List
Chain Link Name
715 051 Platen SS Reduce/Enlarge Adjustment
715 702 Platen FS Reduce/Enlarge Adjustment
Launch Version
WorkCentre 5225, 5230

ADJ 11.6.1 Full/Half Rate Carriage Position Adjustment

Purpose
To adjust the position of the Full/Half Rate Carriage.
Initia
Adjustment
Min. l Max Increment
44 50 56 0.1%
To avoid personal injury or shock, do not perform repair or adjustment with electrical
0 50 100 0.1%
power applied to the machine.
NOTE: Adjust the position of the Front and Rear Full/Half Rate Carriage separately.
1.
2.
February, 2008
4-231
WARNING
Remove the DADF Assembly. (REP 15.1.1)
(Platen models) Remove the Platen Cover.
1. Remove the Platen Cover.
Figure 1 Removing the Platen Cover (j0st41136)
(Figure 1)
Repairs and Adjustments
ADJ 11.2.1, ADJ 11.6.1