Figure 19 Installing the Eject Roll Shaft rear parts (j0st41720)
c.
Install the brass bearing and E-ring onto the front of the Eject Roll Shaft.
Launch Version
WorkCentre 5225, 5230
1
Install
the
brass
Bearing
2
Install the
Gear
3
Install the E-ring
Figure 20 Installing the brass bearing and E-ring on the front of the Shaft (j0st41719)
13. Install the Compiler Tray screw (1).
(Figure
20)
14. Install the Eject Cover.
15. Install the Stacker Upper Cover.
16. Install the Stacker Tray.
17. Install the Stacker Lower Cover.
18. Install the Foot Cover.
19. Install the Rear Upper Cover.
20. Install the Front Cover.
21. Dock the SB Finisher to the Printer IOT.
February, 2008
4-153
(REP
16.2.5)
(REP
16.2.8)
(REP
16.2.16)
(REP
16.2.7)
(REP
16.2.6)
(REP
16.2.3)
(REP
16.2.2)
(REP
16.2.1)
Repairs and Adjustments
REP 16.2.13