Rear Combination Light Assembly - Subaru Legacy 2002 Service Manual

Hide thumbs Also See for Legacy 2002:

Table of Contents

Lighting System

17. Rear Combination Light

S914426A1801

1) Disconnect ground cable from battery.

2) Remove clips and then detach trunk rear trim.

3) Remove hook (A) and then turn over the trunk

side trim of rear portion.

4) Remove harness clip (A).

5) Remove three nuts and then detach rear com-

bination light while disconnecting connector.

S914426A1802

1) Disconnect ground cable from battery.

2) Remove two rear quarter trim covers.

REAR COMBINATION LIGHT ASSEMBLY

3) Remove two nuts and then remove rear combi-

nation light while disconnecting connector.

Before removing the nuts, apply a few turns of

butyl tape to the tip of the service tool. This pre-

vents the nuts from falling during removal.

B: INSTALLATION

Install in the reverse order of removal.

Table of Contents