Procedure After Immobilizer Control Module Replacement; Procedure After Ecm Replacement - Suzuki Wagon R RB310 Supplementary Service Manual

Immobilizer registration menu
F0: Register New Ig Key (Fix Code)
F1: IMMO Cont (Regi Secret Key Code)
F2: ECM (Regi SKC/PWD)
Immobilizer registration menu
F0: Register New Ig Key (Fix Code)
F1: IMMO Cont (Regi Secret Key Code)
F2: ECM (Regi SKC/PWD)
Procedure after immobilizer control module replace-
ment
[When using Tech 1A]
For the procedure, refer to "Procedure after immobilizer control
module replacement" in the same section of the Service manual
mentioned in FOREWORD of this manual.
[When using Tech 2]
1) Perform IMMOBILIZER SYSTEM COMPONENTS REGIS-
TRATION FLOW TABLE.
2) Connect Tech 2 to DLC with ignition switch at OFF position.
3) Turn ignition switch to ON position.
4) Select "Registration" at mode select screen under Immobi-
lizer.
NOTE:
For operation procedure of scan tool, refer to operator's
manual.
5) Perform immobilizer control module registration by selecting
"IMMO Cont (Regi secret key code)".
6) After completing immobilizer control module registration,
register ignition key (fix code) into immobilizer control mod-
ule by performing "Register New Ig Key (Fix Code)" at Immo-
bilizer Registration Menu.

Procedure after ECM replacement

[When using Tech 1A]
For the procedure, refer to "Procedure after ECM replacement" in
the same section of the Service manual mentioned in FORE-
WORD of this manual.
[When using Tech 2]
1) Perform IMMOBILIZER SYSTEM COMPONENTS REGIS-
TRATION FLOW TABLE.
2) Connect Tech 2 to DLC with ignition switch at OFF position.
3) Turn ignition switch to ON position.
4) Select "ECM (Regi SKC/PWD)" at Immobilizer Registration
menu".
IMMOBILIZER CONTROL SYSTEM 8G-3