Suzuki XL7 2007 Service Manual page 1339

Park Brake Cable Adjustment
1. Remove the front floor console. Refer to "Console
Replacement: ".
2. With the park brake lever in the fully released
position, using ONLY hand tools, loosen the
adjusting nut completely to the end of the front cable
threaded rod.
3. Raise the park brake lever 1 detent position.
CAUTION
!
Refer to "Fastener Notice: ".
4. Using ONLY hand tools, tighten the park brake cable
adjusting nut (1) until light to moderate drag is
exhibited while rotating the rear wheels.
5. Attempt to rotate the rear wheels. There should be
no rotation forward or rearward.
6. Fully release the park brake lever.
7. Verify the park brake is released by rotating the rear
wheels. The wheels should rotate freely and exhibit
no park brake shoe drag.
8. If the wheels do not rotate freely, repeat the park
brake cable adjustment procedure.
9. Raise the park brake lever 3 detent positions and
attempt to rotate the rear wheels:
– One of the wheels should not rotate forward or
rearward.
– The other wheel should not rotate forward or
rearward, or should require substantial effort to
rotate.
10. Install the front floor console. Refer to "Console
Replacement: ".
11. Release the park brake lever.
Parking Brake: 4D-7