Suzuki XL7 2007 Service Manual page 1308

4C-6 Rear Brakes:
Step
NOTE
Perform the following inspection AND ANSWER
the question INDIVIDUALLY for EACH rotor.
Inspect each of the disc brake rotors for thickness variation
13
that exceeds the maximum acceptable level. Refer to "Brake
Rotor Thickness Variation Measurement: ".
Does the brake rotor exhibit thickness variation that exceeds
the maximum acceptable level?
1. Inspect each of the disc brake rotors for the following
surface and wear conditions:
Refer to "Brake Rotor Surface and Wear Inspection: ".
– Heavy rust and/or pitting
– Cracks and/or heat spots
– Excessive blueing discoloration
– Deep or excessive scoring beyond maximum
acceptable level
14
NOTE
Make the following determination AND ANSWER
the question INDIVIDUALLY for EACH rotor.
2. Make a determination for each brake rotor if the rotor
requires refinishing based upon the results of the
inspection.
If the brake rotor exhibits any of the conditions listed
previously, it requires refinishing.
Does the brake rotor require REFINISHING?
1. Refinish the brake rotor. Refer to "Brake Rotor Refinishing:
".
2. Inspect the brake rotor thickness. Refer to "Brake Rotor
15
Thickness Measurement: ".
Were you able to REFINISH the brake rotor within the
minimum requirements?
16 Is the brake rotor at or below the DISCARD requirements?
NOTE
Perform the following inspection AND ANSWER
the question INDIVIDUALLY for EACH rotor.
Inspect each of the disc brake rotors for thickness variation
17
that exceeds the maximum acceptable level. Refer to "Brake
Rotor Thickness Variation Measurement: ".
Does the brake rotor exhibit thickness variation that exceeds
the maximum acceptable level?
Action Yes
Go to Step 15 Go to Step 14
Go to Step 15 Go to Step 20
Go to Step 20 Go to Step 19
Go to Step 19 Go to Step 17
Go to Step 19 Go to Step 18
No