Setting Ip Address(Es; D.2.3 Setting Ip Address(Es) - Comtech EF Data CDM-570 Installation And Operation Manual
70/140mhz, l-band,
Hide thumbs
Also See for CDM-570:
- Installation and operation manual (512 pages) ,
- User manual (192 pages) ,
- User manual (146 pages)
Table of Contents
Advertisement
CDM-570/570L Satellite Modem with Optional IP Module
Quick-Start Guide
D.2.3 Setting IP Address(es)
Step
1
From the Main Menu select Network Interface Configuration sub-menu [I].
2
From the Interface Configuration Menu select Ethernet Interface (fei0) sub-menu [E].
3
Set Ethernet IP Address [I].
CDM-IP 1 to 172.16.10.1
CDM-IP 2 to 172.16.10.2
4
Set Subnet Prefix Length [M] to 24
Set Remote HDLC IP Address to 192.168.1.2
The other parameters can be left to their factory default settings.
At this point the basic configuration is over and you should be able to:
5
From PC1
Ping 172.16.10.1 (CDM-IP 1)
Ping 172.16.10.2 (CDM-IP 2)
Ping 172.16.10.12 (PC 2)
6
From PC2
Ping 172.16.10.2 (CDM-IP 2)
Ping 172.16.10.1 (CDM-IP 1)
Ping 172.16.10.11 (PC 1)
Do not enable IF Loopback (or link the TX to RX by a BNC cable or satellite link) on a
CDM-IP modem operating in easyConnect when connected to a LAN. In this
configuration, easyConnect will resend all layer 2 broadcast packets and cause a
IMPORTANT
"broadcast storm" on the LAN.
Description
D–6
Revision 3
MN/CDM570L.IOM
Advertisement
Table of Contents
Troubleshooting
