Ethernet Network Configurations In Router Mode (With Ip Packet Processor; Point-To-Multipoint (Router Multipoint Hub) Mode - Comtech EF Data CDM-425 Installation And Operation Manual

I.4 Ethernet Network Configurations in Router Mode (with IP Packet
Processor)
I.4.1

Point-to-Multipoint (Router Multipoint Hub) Mode

Figure I-10 depicts a Point-to-Multipoint (Router Multipoint Hub) setup, with the optional IP Packet
Processor installed, enabled in the CDM-425 Advanced Satellite Modem, and configured for
Router Mode. This configuration features a Hub Outbound, with a rack of Hub Demods (Rx-only
that are connected on single LAN networks), and Remotes (each) connected to a separate LAN
network).
Appendix I
Figure I-10. Point-to-Multipoint (Router Multipoint Hub Mode)
CDM-425 Advanced Satellite Modem
I–10
Revision 0
MN-CDM-425