Show Lldp Local Tlvs-Overloading - Cisco 300 Series Cli Manual

37
624
Port Capabilities
------ -------------- -------------- ---------- -------------
gi1 Yes
gi2 Yes
gi3 No
Example 2 - The following example displays the LLDP MED configuration for gi1.
switchxxxxxx # show lldp med configuration gi1
Port Capabilities
------- -------------- ---------------- --------- ----------
gi1 Yes
Network policies:
Location:
Civic-address: 61:62:63:64:65:66

37.24 show lldp local tlvs-overloading

When an LLDP packet contains too much information for one packet, this is called
overloading. Use the show lldp local tlvs-overloading EXEC mode command to
display the status of TLVs overloading of the LLDP on all ports or on a specific
port.
Syntax
show lldp local tlvs-overloading
Parameters
interface-id—Specifies a port ID.
Default Configuration
If no port ID is entered, the command displays information for all ports.
Link Layer Discovery Protocol (LLDP) Commands
Network Policy Location
Yes Yes
Yes No
No No
Network Policy Location
Yes Yes
[interface-id]
78-21075-01 Command Line Interface Reference Guide
Notifications Inventory
--------
Enabled Yes
Enabled No
Enabled No
Notifications Inventory
--------
Enabled Yes