Table of Contents
Advertisement
Smartport
Error Handling
NOTE
Error Handling
Default Configuration
Cisco Small Business 200 Series Smart Switch Administration Guide
For more information about LLDP/CDP refer to the
Configuring CDP
sections, respectively.
Persistent Auto Smartport Interface
If the Persistent status of an interface is enabled, its Smartport type and the
configuration that is already applied dynamically by Auto Smartport remains on
the interface even after the attaching device ages out, the interface goes down,
and the device is rebooted (assuming the configuration was saved). The
Smartport type and the configuration of the interface are not changed unless Auto
Smartport detects an attaching device with a different Smartport type. If the
Persistent status of an interface is disabled, the interface reverts to the default
Smartport type when the attaching device to it ages out, the interface goes down,
or the device is rebooted. Enabling Persistent status on an interface eliminates the
device detection delay that otherwise occurs.
The persistence of the Smartport types applied to the interfaces are effective
between reboots only if the running configuration with the Smartport type applied
at the interfaces is saved to the startup configuration file.
When a smart port macro fails to apply to an interface, you can examine the point
of the failure in the Interface Settings page and reset the port and reapply the
macro after the error is corrected from the Interface Settings and Interface
Settings Edit pages.
Smartport is always available. By default, Auto Smartport is enabled by Auto
Voice VLAN, relies on both CDP and LLDP to detect attaching device's Smartport
type, and detects Smartport type IP phone, IP phone + Desktop, Switch, and
Wireless Access Point.
See
Voice VLAN
for a description of the voice factory defaults.
Configuring LLDP
and
10
142
Advertisement
Table of Contents
