Set Dscp (Qos) - Cisco Nexus 7000 Series Command Reference Manual

set dscp (QoS)

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
set dscp (QoS)
To assign a Differentiated Services Code Point (DSCP) value for a class of traffic in a type qos policy
map, use the set dscp command. To remove a previously set DSCP value, use the no form of this
command.
Syntax Description
tunnel
dscp-value
Defaults
None
Command Modes Policy map type qos class configuration
Supported User Roles network-admin
vdc-admin
Command History Release
4.0
4.0.3
Usage Guidelines For a list of standard DSCP values, see
If you configure this value, you cannot configure a value by the set discard-class or set precedence
Note
command.
This command does not require a license.
Examples This example shows how to assign DSCP for a class of traffic in a type qos policy map:
switch(config)# policy-map my_policy1
switch(config-pmap-qos)# class traffic_class2
switch(config-pmap-c-qos)# set cos 3
switch(config-pmap-c-qos)#
Cisco Nexus 7000 Series NX-OS Quality of Service Command Reference, Release 5.x
QOS-78
set dscp [tunnel] dscp-value
no set dscp [tunnel] dscp-value
Sets the DSCP value in the tunnel encapsulation. This keyword is not
supported in Release 4.0.1.
DSCP value or parameter to assign for this class of traffic. Valid values are
from 0 to 63.
Modification
This command was introduced.
The tunnel keyword is supported.
Cisco Nexus 7000 Series NX-OS Quality of Service Commands
Table 2.
OL-23378-01