Qos Map Policed-Dscp - Cisco Sx350 Cli Manual

Quality of Service (QoS) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Example 5—This is an example of the output from show qos interface policer
switchxxxxxx(config)#
gi11
Ethernet
Ingress Policers:
Class map: A
Policer type: aggregate
Commited rate: 19 kbps
Commited burst: 9600 bytes
Exceed-action: policed-dscp-transmit
Class map: B
Policer type: single
Commited rate: 19 kbps
Commited burst: 9600 bytes
Peak rate: 26 kbps
Peak burst: 9600 bytes
Exceed-action: policed-dscp-transmit
Violate-action: drop
Class map: C
Policer type: none
Egress Policers:
Class map: D

47.27 qos map policed-dscp

Use the qos map policed-dscp Global Configuration mode command to configure
the policed-DSCP map for remarking purposes. Use the no form of this command
to restore the default configuration.
Syntax
qos map policed-dscp [violation]
no qos map policed-dscp [violation] [
Parameters
•
violation—Specifies the DSCP remapping in the violate action. If the
keyword is not configured the the command specifies the DSCP remapping
in the exceed action.
show qos interface policer
dscp-list dscp-mark-down
to
dscp-list
]
47
gi11
950