Address Table Commands
78-21075-01 Command Line Interface Reference Guide
Example
The following example registers IP address 239.2.2.2, and forbids the IP address
on port
within VLAN 8.
gi9
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
gi9
29.7
bridge multicast source group
Use the bridge multicast source group Interface Configuration (VLAN) mode
command to register a source IP address - Multicast IP address pair to the bridge
table, and statically add or remove ports to or from the source-group. Use the no
form of this command to unregister the source-group-pair.
Syntax
bridge multicast source
{ethernet interface-list | port-channel port-channel-list}]
no bridge multicast source
Parameters
•
ip-address—Specifies the source IP address.
•
ip-multicast-address—Specifies the group IP Multicast address.
•
add—Adds ports to the group for the specific source IP address.
•
remove—Removes ports from the group for the specific source IP address.
•
interface-list
ethernet
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel-list
port-channel
nonconsecutive port-channels with a comma and no spaces; use a hyphen
to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
8
interface vlan
bridge multicast ip-address
bridge multicast forbidden ip-address
ip-address
ip-multicast-address [[add | remove]
group
ip-address
group
—Specifies a list of Ethernet ports. Separate
—Specifies a list of port channels. Separate
239.2.2.2
ip-multicast-address
29
239.2.2.2
add
411