Bridge Multicast Source Group - Cisco Sx350 Cli Manual

Address Table Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Before defining forbidden ports, the Multicast group should be registered.
You can execute the command before the VLAN is created.
Example
The following example registers IP address 239.2.2.2, and forbids the IP address
on port gi14 within VLAN 8.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
gi14
4.7

bridge multicast source group

To register a source IP address - Multicast IP address pair to the bridge table, and
statically add or remove ports to or from the source-group, use the bridge
multicast source group Interface (VLAN) Configuration mode command. To
unregister the source-group-pair, use the no form of this command.
Syntax
bridge multicast source
interface-list |
{ethernet
no bridge multicast source
Parameters
•
ip-address—Specifies the source IP address.
•
ip-multicast-address—Specifies the group IP Multicast address.
•
add—(Optional) Adds ports to the group for the specific source IP address.
•
remove—(Optional) Removes ports from the group for the specific source
IP address.
interface vlan 8
bridge multicast ip-address 239.2.2.2
bridge multicast forbidden ip-address 239.2.2.2 add
ip-address ip-multicast-address
group
port-channel-list
port-channel
ip-address
group
[[add | remove]
}]
ip-multicast-address
4
132