Dot1X Timeout - Cisco ME 3400 Command Reference Manual

Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands

dot1x timeout

Use the dot1x timeout interface configuration command to set IEEE 802.1x timers. Use the no form of
this command to return to the default setting.
Syntax Description
quiet-period seconds
reauth-period seconds
server-timeout seconds
supp-timeout seconds
tx-period seconds
Defaults These are the default settings:
reauth-period is 3600 seconds.
quiet-period is 60 seconds.
tx-period is 30 seconds.
supp-timeout is 30 seconds.
server-timeout is 30 seconds.
Command Modes Interface configuration
Command History Release
12.2(25)EX
12.2(40)SE
Usage Guidelines
You should change the default value of this command only to adjust for unusual circumstances such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
OL-9640-10
dot1x timeout {quiet-period seconds | reauth-period seconds | server-timeout seconds |
supp-timeout seconds | tx-period seconds}
no dot1x timeout {quiet-period | reauth-period | server-timeout | supp-timeout | tx-period}
Number of seconds that the switch remains in the quiet state following a
failed authentication exchange with the client. The range is 1 to 65535.
Number of seconds between re-authentication attempts. The range is 1 to
65535.
Number of seconds that the switch waits for the retransmission of packets
by the switch to the authentication server. The range is 1 to 65535.
However, we recommend a minimum setting of 30.
Number of seconds that the switch waits for the retransmission of packets
by the switch to the IEEE 802.1x client. The range is 30 to 65535.
Number of seconds that the switch waits for a response to an
EAP-request/identity frame from the client before retransmitting the
request. The range is 1 to 65535.
Modification
This command was introduced.
The range for tx-period seconds is incorrect. The correct range is from 1 to
65535.
Cisco ME 3400 Ethernet Access Switch Command Reference
dot1x timeout
2-101