Radius-Server Key - Cisco 300 Series Cli Manual

RADIUS Commands
OL-32830-01 Command Line Interface Reference Guide
Example
The following example specifies a RADIUS server host with IP address
192.168.10.1, authentication request port number 20, and a 20-second timeout
period.
switchxxxxxx(config)#

40.2 radius-server key

Use the radius-server key Global Configuration mode command to set the
authentication key for RADIUS communications between the device and the
RADIUS daemon. Use the no form of this command to restore the default
configuration.
Syntax
key-string
radius-server key [
encrypted radius-server key [
no radius-server key
Parameters
•
key-string
—Specifies the authentication and encryption key for all RADIUS
communications between the device and the RADIUS server. This key must
match the encryption used on the RADIUS daemon. (Range: 0–128
characters)
•
encrypted-key-string
encrypted form.
Default Configuration
The key-string is an empty string.
Command Mode
Global Configuration mode
radius-server host 192.168.10.1
]
encrypted-key-string
—Same as the key-string parameter, but the key is in
auth-port 20 timeout
]
40
20
790