Snmp-Server Engineid Remote - Cisco 300 Series Cli Manual

12
214
When configuring SNMP v1 or v2 notifications recipient, the software
automatically generates a notification view for that recipient for all MIBs.
For SNMPv3 the software does not automatically create a user or a notify view.
Use the commands snmp-server user
group.
Example
The following defines a host at the IP address displayed.
switchxxxxxx(config)# snmp-server host 1.1.1.121 abc

12.13 snmp-server engineID remote

To specify the SNMP engine ID of a remote SNMP device, use the snmp-server
engineID remote Global Configuration mode command. Use the no form of this
command to remove the configured engine ID.
Syntax
snmp-server engineID remote
no snmp-server engineID remote
Parameters
•
ip-address —IPv4, IPv6 or IPv6z address of the remote device. See
Address Conventions.
•
engineid-string—The character string that identifies the engine ID. The
engine ID is a concatenated hexadecimal string. Each byte in hexadecimal
character strings is two hexadecimal digits. Each byte can be separated by
a period or colon. If the user enters an odd number of hexadecimal digits,
the system automatically prefixes the hexadecimal string with a zero.
(Range: engineid-string5–32 characters. 9–64 hexadecimal digits)
Default Configuration
The remote engineID is not configured by default.
Command Mode
Global Configuration mode
Network Management Protocol (SNMP) Commands
and snmp-server group
{ip-address} engineid-string
{ip-address}
78-21075-01 Command Line Interface Reference Guide
to create a user or a
IPv6z