Send; Service-Type Telnet - Huawei Quidway S2000 Series Command Manual

Command Manual - Getting Started
Quidway S2000 Series Ethernet Switches

1.1.19 send

Syntax
send { all | number | type number }
View
User view
Parameter
all: Configures to send message to all user interfaces.
type: Specifies the user interface type, which can be aux or vty.
number: Specifies the absolute/relative number of the user interface.
Description
Using send command, you can send messages between different user interfaces.
Example
# Send message to all the user interfaces.
<Quidway> send all

1.1.20 service-type telnet

Syntax
service-type telnet [ level level ]
undo service-type telnet [ level ]
View
Local-user view
Parameter
level: Specifies which level of command a user can use after logon, ranging from 0 to 3
and defaults to level 1.
Description
Using service-type telnet command, you can configure which level of command a
user can use after logon. Using undo service-type telnet command, you can restore
the default level of command a user can use after logon.
Commands are classified into four levels, namely visit level, monitoring level,
configuration level and management level. They are introduced as follows:
Chapter 1 Logging in Ethernet Switch Commands
1-14