Display And Debug System Ip - Huawei Quidway S5000 Series Operation Manual - Getting Started

Operation Manual - Getting Started
Quidway S5000 Series Ethernet Switches
Table 5-8 Configure the default preference of static routes
Configure the default preference value of static routes
Remove the default preference value of static routes configure
By default, its value is 60.

5.3 Display and Debug System IP

After the above configuration, execute display command in any view to display the
running of the system IP configuration, and to verify the effect of the configuration.
Table 5-9 Display and debug system IP
View all the hosts and their IP addresses on the network
View related IP information of the management VLAN
interface
View related information of the management VLAN interface
View routing table summary
View routing table details
View the detailed information of a specific route
view the route information in the specified address range
Operation
Operation
5-7
Chapter 5 System IP Configuration
Command
ip route-static default-preference
default-preference-value
undo ip route-static default-preference
Command
display ip host
display ip interface vlan-interface vlan-id
display interface vlan-interface [ vlan_id ]
display ip routing-table
display ip routing-table verbose
display ip routing-table ip-address [ mask ]
[ longer-match ] [ verbose ]
display ip routing-table ip_address1 mask1
ip_address2 mask2 [ verbose ]