Configuring Remote Port Mirroring; Configuring A Remote Source Mirroring Group - H3C S5500-EI series Operation Manual

Operation Manual – Port Mirroring
H3C S5500-EI Series Ethernet Switches
Note:
A local mirroring group is effective only when it has both source ports and the
destination port configured.
It is not recommended to enable STP, RSTP or MSTP on the destination port;
otherwise, the mirroring function may be affected.
Do not use the destination mirroring port for any purpose other than port mirroring.
The source ports and the destination port cannot be the member ports of the current
mirroring group.
Before adding the destination port for a port mirroring group, make sure the port
mirroring group exists. A mirroring group can have only one destination port.

1.3 Configuring Remote Port Mirroring

1.3.1 Configuring a Remote Source Mirroring Group

Follow these steps to configure a remote port mirroring group
Enter system view
Create a remote
source mirroring group
Add ports
to the
mirroring
group as
source
ports
Add a
port to
the
mirroring
group as
the
outbound
mirroring
port
To do...
system-view
mirroring-group group-id
remote-source
mirroring-group group-id
In system
mirroring-port mirroring-port-list
view
{ both | inbound | outbound }
interface interface-type
interface-number
In
[ mirroring-group group-id ]
interface
mirroring-port { both | inbound
view
| outbound }
quit
mirroring-group group-id
In system
monitor-egress
view
monitor-egress-port-id
interface interface-type
interface-number
In
interface
mirroring-group group-id
view
monitor-egress
quit
Chapter 1 Port Mirroring Configuration
Use the command...
1-4
Remarks
—
Required
Use either approach.
You can add ports to
a source port
mirroring group in
either system view or
interface view. They
achieve the same
purpose.
Use either approach.
You can add ports to
a source mirroring
group in either system
view or interface view.
They achieve the
same purpose.