Table of Contents
Advertisement
MSAP2000 AAMS User's Guide
Table 27
LABEL
Delete
Cancel
boxes. Active
Name
VLAN ID
4094. Port
Control
Tagging
Add
Cancel
8.6 VLAN Port Setting
Click Advanced and then VLAN in the navigation panel and then the VLAN Port
Setting
link to display the screen as shown next.
Use this screen to specify port VLAN IDs and to set whether or not Ethernet ports
propagate
VLAN information to other switches.
Static VLAN Setting (continued)
DESCRIPTION
Select the check boxes of the rules that you want to remove in the Delete column
and then click the Delete button.
You cannot delete a VLAN if any PVIDs are set to use the VLAN or the VLAN is
the CPU (management) VLAN. The DEFAULT VLAN cannot be deleted when a
port's PVID refers to it. The CPU VLAN also cannot be deleted.
Click Cancel to clear the Delete check
Select this check box to enable the VLAN.
You cannot disable a VLAN if any PVIDs are set to use the VLAN or the VLAN is the
CPU (management) VLAN.
Enter a descriptive name for this VLAN group for identification purposes.
Enter the VLAN ID for this static VLAN entry; the valid range is between 1 and
The port numbers identify the MSAP2000 AAMS's ports.
Select Normal for the port to dynamically join this VLAN group using GVRP.
This is available for the Ethernet ports.
Select Fixed for the port to be a permanent member of this VLAN group. Use the
Select All button to include every port.
Select Forbidden if you want to prohibit the port from joining this VLAN group.
Use the Select All button to include every port.
You cannot change a port from the fixed state to another state if the port's PVID is
set to this VLAN. The VLAN must have at least one port set to the fixed status if
the VLAN is the CPU (management) VLAN.
Select Tx Tagging if you want the port to tag all outgoing frames transmitted with
this VLAN group ID. Use the All button to include every port. Use the None
button to clear all of the ports' check boxes.
Click Add to save your settings. The VLAN then displays in the summary table at
the top of the screen.
Clicking Add saves your changes to the MSAP2000 AAMS's volatile memory.
The MSAP2000 AAMS loses these changes if it is turned off or loses power, so
use the Config Save link on the navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
89
Advertisement
Table of Contents
