Table of Contents
Advertisement
The following table describes the items on the Zyxel Device's rear panel.
Table 2 Rear Panel
LABEL
POWER
UPS
RESET
10G LAN (for
PM7516-R0)
1G LAN (for
PM7116-R0)
VoIP
The following table describes the LED of the LAN port on the rear panel.
Table 3 Rear Panel LED
LED
10G LAN (for
P7516-R0)
1G LAN (for
P7116-R0)
1.4.3 UPS Port
You can connect a UPS to the UPS port to keep the Zyxel Device running in case the main power fails.
The following diagram and chart show the pin assignments of the UPS port on the Zyxel Device.
Note: The main power and UPS cannot be used at the same time.
Figure 5 UPS Port Pin Layout
Table 4 UPS Port Pin Assignment
PIN
UPS PORT
1
VCC_12VDC
2
UPS status: On battery
3
UPS status: Battery missing
Chapter 1 Introduction
DESCRIPTION
Connect the power cable to start the Zyxel Device.
Connect a UPS (Uninterruptible Power Supply) to the UPS port to have a backup power source
when the main power fails.
Press the recessed button for more than 5 seconds (or until the POWER LED starts to blink), then
release it to return the Zyxel Device to the factory defaults (the randomly assigned default
password, LAN IP address 192.168.0.1 etc.)
Connect computers, IPTVs, gaming consoles, and other Ethernet devices to this port for up to 10
Gbps Internet access.
Connect computers, IPTVs, gaming consoles, and other Ethernet devices to this port for up to 1
Gbps Internet access.
Connect an analog phone to the VoIP port to make phone calls.
COLOR
STATUS
DESCRIPTION
Green
On
The Zyxel Device's 10 Gbps LAN connection is ready.
Blinking
Data is being transmitted/received at 10 Gbps.
Off
No Ethernet device connected.
Green
On
The Zyxel Device's 1 Gbps LAN connection is ready.
Blinking
Data is being transmitted/received at 1 Gbps.
Off
No Ethernet device connected.
PM7516-R0 / PM7116-R0 User's Guide
11
Advertisement
Table of Contents
