Static Entries (Svlan Table); Dynamic Entries (Dvlan Table); Ieee Vlan1Q Tagged Vlan Configuration Commands; Garp Timer Show Command - ZyXEL Communications Multi-service Access Platform MSAP2000 User Manual

MSAP2000 AAMS User's Guide

27.7.1 Static Entries (SVLAN Table)

Static entry registration information is added, modified and removed by
administrators only.

27.7.2 Dynamic Entries (DVLAN Table)

Dynamic entries are learned by the MSAP2000 AAMS and cannot be created or
updated by administrators. The MSAP2000 AAMS learns this information by
observing what port, source address and VLAN ID (or VID) is associated with a
frame. Entries are added and deleted using GARP VLAN Registration Protocol
(GVRP), where GARP is the Generic Attribute Registration Protocol.
27.8 IEEE VLAN1Q Tagged VLAN Configuration
Commands
These switch commands allow you to configure and monitor the IEEE 802.1Q
Tagged VLAN.

27.8.1 GARP Timer Show Command

Syntax:
ras> switch garptimer show
This command shows the MSAP2000 AAMS's GARP timer settings, including the
join, leave and leave all timers.
An example is shown next.
Figure 113
ras> switch garptimer show join
time
leave time
leaveall time (ms): 10000

27.8.2 GARP Timer Join Command

Syntax:
ras> switch garptimer join <join msec>
where
<join msec>
GARP Timer Show Command Example
(ms): 200
(ms): 600
= This sets the duration of the Join Period timer for
GVRP in milliseconds. Each port has a Join Period
timer. The allowed Join Time range is between 100
and 32767 milliseconds; the default is 200
milliseconds.
201