Using Ftp Or Tftp To Back Up Configuration; Using The Ftp Commands To Back Up Configuration; Ftp Command Configuration Backup Example; Figure 180 Ftp Session Example - ZyXEL Communications Network Device P-2602 User Manual

P-2602H(W)(L)-DxA Series User's Guide

25.7 Using FTP or TFTP to Back Up Configuration

This section covers how to use FTP or TFTP to save your device's configuration file to your
computer.

25.7.1 Using the FTP Commands to Back Up Configuration

1 Launch the FTP client on your computer.
2 Enter "
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is "1234").
5 Enter "
6 Use "
get
rom-0 config.rom
computer and renames it "
on filename conventions.
7 Enter "

25.7.2 FTP Command Configuration Backup Example

This figure gives an example of using FTP commands from the DOS command prompt to save
your device's configuration onto your computer.

Figure 180 FTP Session Example

331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
308
", followed by a space and the IP address of your ZyXEL Device.
open
" to set transfer mode to binary.
bin
" to transfer files from the ZyXEL Device to the computer, for example, "
" transfers the configuration file on the ZyXEL Device to your
config.rom
" to exit the ftp prompt.
quit
". See earlier in this chapter for more information
get
Chapter 25 Tools