Desktop Installation Procedure; Rack-Mounting - ZyXEL Communications USG FLEX H Series User Manual

WARNING! Do NOT block the ventilation holes on the Zyxel Device.
Allow 100 mm clearance for the ventilation holes to prevent your Zyxel
Device from overheating. Do not store things on the Zyxel Device. Do
not place a Zyxel Device on another high temperature device.
Overheating could affect the performance of your Zyxel Device, or
even damage it.

3.2.1 Desktop Installation Procedure

Make sure the Zyxel Device is clean and dry.
1
Remove the adhesive backing from the rubber feet.
2
Attach the rubber feet to each corner on the bottom of the Zyxel Device. These rubber feet help
3
protect the Zyxel Device from shock or vibration, and allow air circulation.
Figure 42 Attaching Rubber Feet
Set the Zyxel Device on a smooth, level surface strong enough to support the weight of the Zyxel Device
4
and the connected cables. Make sure there is a power outlet nearby.
Note: Make sure to use the rubber feet when stacking the Zyxel Devices on a desk.

3.2.2 Rack-mounting

Use the following steps to mount the Zyxel Device on an EIA standard size, 19-inch rack or in a wiring
closet with other equipment using a rack-mounting kit. Make sure the rack will safely support the
combined weight of all the equipment it contains and that the position of the ZyWALL does not make
Chapter 3 Hardware, Interfaces and Zones
USG FLEX H Series User's Guide
50