The Setup Lan Interface Screen - ZyXEL Communications FMG Series User Manual

4.2 The Setup LAN Interface Screen

Use this screen to set the Local Area Network IP address and subnet mask of your FMG. Click LAN > Setup
LAN Interface to open the Setup LAN Interface screen.
Follow these steps to configure your LAN settings.
Enter an IP address into the IP Address field. The IP address must be in dotted decimal notation. This will
1
become the IP address of your FMG.
Enter the IP subnet mask into the Subnet Mask field. Unless instructed otherwise it is best to leave this
2
alone, the configurator will automatically compute a subnet mask based upon the IP address you
entered.
Click Apply Changes to save your settings.
3
If the FMG has a WAN IP address, this screen won't be configurable.
Figure 13 LAN > Setup LAN Interface
The following table describes the fields in this screen.
Table 10 LAN > Setup LAN Interface
LABEL
LAN Interface Settings
IP Address
Subnet Mask
Apply Changes
Chapter 4 LAN
DESCRIPTION
Enter the LAN IPv4 IP address you want to assign to your FMG in dotted decimal notation, for
example, 192.168.1.1 (factory default).
Type the subnet mask of your network in dotted decimal notation, for example 255.255.255.0
(factory default). Your FMG automatically computes the subnet mask based on the IP address
you enter, so do not change this field unless you are instructed to do so.
Click Apply Changes to save your changes.
FMG Series User's Guide
24